Conair CSC User's Guide download pdf (Page 72)

CSC Servo Knife Cutters UGE047/1003

5-8 MAINTENANCE

This tray is built into the cutter assembly as a simple method

of applying lubrication to your blade during cutting cycles.

Depending on cut rate and type of material and lubrication,

the area will need to be cleaned on a regular basis and the

lubricant replaced. Open the knife guard and, using a shop vac

or other similar equipment, remove all liquid and solids from

the cutting chamber and around the bushings. Replace the

lubricant. For more information, see the Appendix D, Blade

and Bushing Lubrication.

CLEANING THE

BLADE T

RAY

Check the shafts on the slide rail system. Even though these

shafts are stainless steel, it is recommended that a light oil

(WD-40 or similar) be applied to the shafts as needed. Wipe

off any excess.

UBRICATING

THE

SLIDE RAIL

SYSTEM

Lubricant Tray

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 107 108

No comments

Conair CSC User's Guide Page 72